READ Free Dumps For CISCO- 100-105

Question ID 14649	What is one requirement for interfaces to run IPv6?
Option A	An IPv6 address must be configured on the interface.
Option B	An IPv4 address must be configured.
Option C	Stateless autoconfiguration must be enabled after enabling IPv6 on the interface.
Option D	IPv6 must be enabled with the ipv6 enable command in global configuration mode.
Correct Answer	A

Explanation Explanation: To use IPv6 on your router, you must, at a minimum, enable the protocol and assign IPv6 addresses to your interfaces.

Question ID 14650	Which NAT type is used to translate a single inside address to a single outside address?
Option A	dynamic NAT
Option B	NAT overload
Option C	PAT
Option D	static NAT
Correct Answer	D

Explanation Explanation: Network address translation (NAT) is the process of modifying IP address information in IP packet headers while in transit across a traffic routing device. There are two different types of NAT: ✑ NAT ✑ PAT

Previous-Page 1 2... 135 136 137 138 139 140 141 142 143 Next-Page

Send email to admin@getfreedumps for new dumps request!!!